| Mounting Brackets | Not Required |
| Notes | Standalone FAL raises 25mm at shock |
| Front lbs/inch | Front N/mm | Rear lbs/inch | Rear N/mm |
| Spring Spec | 400 | 70 | 650 | 114 |
Fast Road (40mm Piston) 1-Way Adjustable
The Fast Road is the entry level NTR shock available as a 1-way adjustable damper. This shock is popular with predominantly road-use customers who drive hard and fast; demanding the best from the chassis but require a degree of comfort.
Softer valving and springs combined with the ability to run at original ride heights (and slightly lowered if required) result in a great road shock with superb all-round capabilities.
As this shock is part of the NTR range it will perform consistently during a week of blasting round the Nurburgring if required and can be rebuilt to any of the other NTR specifications in the future.
The kit comprises four 1-way adjustable dampers with fitted springs. The single adjuster knob affects both bump and rebound for simple setup with a road-biased spec. These shocks are designed to run inverted for reduced unsprung mass and therefore optimum performance. Dampers are delivered preset with a full compliment of bearing spacers ready to fit to the car.
Customised spring rates are available at no extra charge.
Note: Image used for illustration purposes only. Specific shock end fittings may differ from that shown.
All Nitron shocks are hand made to order to each individual customer's requirements. Lead times are normally 2-3 weeks, but at certain times may be slightly longer.
Front Axle Lift (FAL)
This kit is supplied with the Nitron standalone Front Axle Lift system, letting you raise the front axle to clear speed bumps, ramps and steep driveways without affecting damping performance.
Key features:
- Kit contains all components – lift cylinders, hydraulic lines, pump, mounting bracket, wiring loom and controller
- 250W pump, typical lift time under 3 seconds
- Audible in-cabin warning system and switch with built-in warning light
- Auto-off function
- Lift height varies by application – see the specification table below